Hip Roof Ridge Board

Length of Hip Roof Ridge Board

While the ridge board length on a gable roof is simple, a hip roof is
only slightly more difficult to figure. A gable ridge is the same length
as the building plus the overhang on either end. A hip roof ridge is
the width of the structure, plus the thickness of the ridge,
subtracted from the buildings length.

To find the ridge board length you simply measure
the length of the building, then the width, add the ridge thickness to
the building width, and subtract this total from the length.

Finding Ridge Board Length

I will walk you thru the steps I use to find the ridge length for a 12 foot by 28 foot building requiring a simple hip roof.

At this point the pitch of the roof doesn’t matter, we need to find the run of the common rafter. Measure the width of the building and mark the exact center, 12 feet divided by 2 = 6 feet.
This is the center of the ridge, now lay out the thickness of the
ridge. If the ridge is 1 1/2 inches thick make a mark 3/4 of an inch on
either side of this line. Measure from the outside corner to the marks that represent the ridge. You should come up with 5′ 11 1/4″.

Now measure along the length of the building from both ends and mark 5′ 11 1/4″, now if you measure between these two marks you will have the length of the ridge board.

Notice how it works out, length minus width plus 1 1/2 inches.

Ridge & Common Rafter

If you’re not confident cutting the ridge to length before putting it up
there is a different way of cutting it to length. Instead of putting up
the common rafters on the very end use the ones one layout mark from
where you think the ridge should end and leave it a foot long or so.
Then just use the king common to mark the cut on the end of the ridge.

Links to Related Carpentry Pro Framer Pages

Ridge Board to Homepage

Hip Basics

Framing a Hip Roof

Pyramid Roof

Site Map

Cutting Hip Rafters

Dropping Hip Rafters

Hip Rafter Length

Top of Page